|
Switching to the next
caller
Proceed as follows:
| 1. |
Tell the person with whom you are speaking
that you have another call and ask him or her to wait while you take the new call. |
| 2. |
Consecutively push the buttons |
 |
and |
 |
. By doing so you connect |
|
to a new call and the original
caller waits until you finish the new call and resume the original one again. |
| 3. |
After finishing the new call,
resume the original call by consecutively pushing the buttons |
and  |
Switching to the next caller by terminating the
original call
If you have another incoming call to your telephone as you
are finishing the original call, you can first finish the original call (within 10
seconds) and then hang up. Immediately after hanging up, your telephone will begin to ring
and after accepting the call you can begin talking to the next caller.
If you decide that you do not want to receive a new call, you can continue with the
original call. The next caller will continue to hear a ringing signal. If you do not
connect or hang up, the caller will hear the busy signal after approximately 20 seconds.
However, if you have conditional call forwarding to the Message Service or another number,
the call will be forwarded there.
| List of used button
combinations |
| |
 |
cancel connection with caller waiting |
|
|
cancel ongoing call and continue with waiting
caller |
|
|
switch callers ("waiting" –
"speaking" and vice versa) |
|
|
|
 |
switch to conference call (see
"Conference Call") |
| Important notice: |
| If your telephone does not have a button with
the letter |
|
, in the instructions |
| on using your telephone you can
find the button which replaces it on your mobile telephone keypad. |
|
|
